USB KKL VAG-COM For 409.1 VW/AUDI OBD2 with FT232RL 黑色

his VAG_COM OBD II interface enables you to connect your PC to your car so that you can troubleshoot any problems in your vehicle by reading the Diagnostic Trouble Codes (DTC’s) that appear when the ‘check engine’ light is showing.Workable ModelsThis diagnostic cable is usable for ISO9141 and KWP2000 transmission protocol (16pin OBD II style Data Link Connector).Reference Data

This cable can not work if your car uses a protocol/bussystem like VPW, PWM or CAN-bus.

Terminal K = Bus of communication

Terminal L = Ignition for waking up car computing system (ECU: Engine Control Unit)

Existed 3 different protocols with same OBD2 connector incl. ISO/KWP, VPW, PMW

This K/L Diagnostic interface & cables work>Supported also ISO9141 protocol

The Cables may work with some versions of the Carsoft, but carsoft used a lot of different interfaces during the different versions and also had some custom interfaces. 

Features

Supports VAG-COM version 409.1 or older

Fully automatic support for 2002+ Audi models with dual K-lines

High quality precision moulded diagnostic connector made to fit all Audi/VW vehicles

LED light shows cable communication status

Fully CE approved

In-built electronic protection from ‘aftermarket radio problems’

This purchase is for>About VAG-COMVAG-COM is a Windows based diagnostic software for Volkswagen, Audi, Seat and Skoda vehicles that emulates the functions of expensive professional scan tools. It is:

Fully compatible with all models of the above makes of car or van produced between 1996 and 2006 (see below for more information>Compatible with the above makes of car with CAN connection

Has a data base of more than 7500 fault codes and measuring block texts

Can use the new 7 digit PIN/SKC codes to match new keys in all immobilizer-equipped W, Audi, Seat and Skoda models

Is my Car VAG-COM Compatible?VAG-COM will work with most Volkswagen and Audi models sold worldwide from 1994> 

What System Requirements do I Need?A PC or laptop that is running Windows 95, 98, ME, NT4, 2000 or XP. A Pentium 100 (or AMD equivalent) that has 16MB of RAM is recommended. VAG-COM>Run it, follow the prompts and let it install (on your PC or laptop’s hard disk)

Plug>Turn>Start the VAG-COM programme, click ‘options’, select the correct communications port and run the test to confirm that the programme is working and can find the interface. Click ‘save’.

We want to make it even easier for you to use your OBDII USB cable, so here are some links to sites where you can download the software:Free Software

Scantool

OBD Gauge by Dana Peters

OBD Loggerby Jonathan Senkerik

OBD-II ScanMasterby Wladimir Gurskij

obd2crazy

OBD2 Scantoolby Ivan Andrewjeski

OBDII for ELM322by David Huffman

RDDTCby Pete Calinski

Real Scanby Brent Harris

ScanTestby Ivan Ganev

Software Available to Purchase

Digimoto

PCMSCAN

ProScan

博世BOSCH、电装、德尔福、西门子等厂家特约经销商